A wide range of high quality controllers for various power applications

The Tips of HGM6100N Series Control Module

The Tips of HGM6100N Series Control Module

he parameter display of ECU engine shutdown

We want to check the parameters of the engine when the engine is shutdown. What should we do? Rewiring the ECU to power on? For the ECU engine, when we press the start button of control module in stop mode, the control module will power up the ECU but not start the engine, so you can check the engine parameters.

Force Start

When the generator sets need to be forced to start, the control module can compulsively start the generator set by pressing the mobile phone key and the start key at the same time. The control module does not judge the generator set crank successfully or not according to the crank successfully conditions. The departure of starter is controlled by the operator.

Screen Backlight

The control module shuts it down automatically to reduce power consumption after the backlight works for a while. If the user is not used to this function, we can turn it off. The operation is as follows: press the down key and up key at the same time, the backlight of the screen will be on or off all the time.

Automatic Identification of Flywheel Teeth

In the flywheel teeth configuration interface, flywheel teeth configuration state and frequency is greater than 20 Hz. Press the start button, the control module will automatically calculate flywheel teeth. Then press the confirmation key to change flywheel teeth.
01.09.2018

Back to the list